Integrated mechanical, electrical, and plumbing systems — designed for peak performance, energy efficiency, and long-term reliability in Oman's demanding climate conditions.
MEP engineering encompasses the design of all building services systems — the mechanical systems that condition and ventilate spaces, the electrical systems that power and illuminate them, and the plumbing systems that supply water and remove waste.
In Oman's extreme climate, MEP design is critical. Our team optimises every system for Gulf conditions — minimising energy consumption while maintaining comfort and compliance with ASHRAE, NFPA, and local DCRP requirements.
Load calculations, equipment selection, duct/pipe design, and energy modelling for Gulf climate performance.
LV/MV distribution, lighting design, power systems, earthing, and emergency power with DIALux modelling.
Cold/hot water supply, drainage, fire suppression, and hydrant systems to NFPA and local standards.
A coordinated, discipline-by-discipline approach to building services design.
Thermal load calculations (HAP), electrical demand analysis, and plumbing fixture unit counts to establish system sizing basis.
Air handling unit selection, duct network sizing, VAV/FCU layouts, and chiller plant design optimised for Gulf ambient conditions.
Power distribution network, lighting layout with DIALux calculations, earthing system, and emergency/UPS provisions.
Cold and hot water distribution, sanitary drainage, grease traps, and rainwater systems designed to ADSSS and local standards.
Sprinkler system design to NFPA 13, fire alarm layout, hydrant network, and smoke control systems for full life-safety compliance.
All MEP systems coordinated in 3D, clashes resolved, and full construction drawing set produced for site installation.
Load calculations, equipment schedules, duct layout drawings, and technical specifications for all mechanical systems.
Single line diagrams, distribution board schedules, lighting layouts, earthing drawings, and load calculations.
Water supply riser diagrams, drainage layout plans, and fixture schedules with pipe sizing calculations.
Sprinkler hydraulic calculations, layout drawings, fire alarm point schedule, and hydrant network design.
Energy performance report demonstrating compliance with ASHRAE 90.1 and Estidama/green building requirements.
Coordinated MEP routing drawings showing all services in 3D space — clash-free and ready for installation.
HVAC load calculations and energy simulation for accurate cooling and heating system sizing.
Lighting design and calculation software for compliant illuminance levels and energy-efficient fixtures.
Mechanical, electrical, and plumbing drafting and coordination within the AutoCAD environment.
BIM-based MEP modelling for full coordination with architectural and structural models.
A specialist medical facility requiring complex MEP systems — including precision HVAC for operating theatres, medical gas systems, isolated power for ICU, and a full NFPA 13 sprinkler network across 6 floors.
MEP works best when fully coordinated with architecture and structure.
Ceiling heights, shaft locations, and plant room space allocated in coordination with MEP routing.
MEP systems routed in the federated BIM model with zero clash guarantee before construction.
Structural penetrations, openings, and MEP support loads coordinated with structural design.
Tell us about your project and our MEP team will provide a detailed scope and fee proposal within 48 hours.
